Categories
Categories
- Spare parts for boilers and heaters
- Gas
- Gas boilers
- Pumps
- Water Heaters
- Heating system filters - water
- Solenoid valves
- Gaskets
- Gas heaters
- Protective and cleaning agents
- Electric boilers
- Expansion vessels
- Water meters
- Pressure gauges and thermo-manometers
- Actuators and solenoid valves (ESBE)
- Controls
- Radiator heads
- Thermometers
- Valves and fittings
- Piping and drainage systems
- Home and Garden
- Others
Thermometer well DTU 250 mm APATOR - JDTU250
Description: Thermometer well DTU 250 mm APATOR - JDTU250 Thermometer stem length: 250 mm Well length: 255 mm Material: cathodic-etched painted steel* The thermometer well is designed to protect the thermometer stem from environmental influences at the installation site. The well is designed to be built into a designated device (e.g. electric boiler, water heater). The well is installed by screwing the well neck into the device casing using a suitable seal. The thermometer is installed by sliding the thermometer stem into the well of the designated size and securing it with an M5 x 8 screw. The maximum working overpressure of the wells is PN 6 according to ČSN 130010. The pressure leak test is performed during production with air under the water surface for all manufactured wells. In addition to the maximum working overpressure, the maximum working temperature is also marked on the well. *Cathophrenic painting is one of the most modern ecological technologies for surface treatment of metal products. Treated products are resistant to corrosion, abrasion, impact
Code:034023230400 / JDTU250
Manufacturer:
Availability:In stock 1 ks
Price with VAX:10,00 €
Product description
Thermometer well DTU 250 mm APATOR - JDTU250
Thermometer stem length: 250 mm
Well length (L): 255 mm
Thread diameter: 1/2"
Inner diameter: 8.5 mm
Outer diameter: 12 mm
Material: steel
Surface finish: chrome plated
The thermometer well is designed to protect the thermometer stem from environmental influences at the installation site. The well is designed to be built into a designated device (e.g. electric boiler, water heater).
The sump is installed by screwing the sump neck into the device casing using a suitable seal.
The thermometer is installed by inserting the thermometer stem into the well of the specified size and securing it with an M5 x 8 screw.
The maximum working pressure of the sumps is PN 6 according to ČSN 130010. The pressure leak test is performed during production with air under the water surface for all manufactured sumps. In addition to the maximum working pressure, the maximum working temperature is also marked on the sump.